🎁 A holiday package to celebrate the season! Click here and shop now!

TextRanch

The best way to perfect your writing.

Discover why 1,062,726 users count on TextRanch to get their English corrected!

1. Input your text below.
2. Get it corrected in a few minutes by our editors.
3. Improve your English!

One of our experts will correct your English.

Our experts

measured values vs values measured

Both 'measured values' and 'values measured' are correct and commonly used in English. The choice between them depends on the emphasis you want to give in the sentence.

Last updated: March 26, 2024 • 512 views

measured values

This phrase is correct and commonly used in English.

This phrase is used when you want to emphasize that the values have been measured. 'Measured values' is a common collocation in technical and scientific contexts.

Examples:

  • The experiment produced accurate measured values.
  • The sensor recorded the measured values of temperature and humidity.
  • "Linearity" means the degree to which measured values agree with respective reference values.
  • Otherwise the measured values shall be marked 'non-comparable'.
  • The measured values of gaseous and particulate pollutants exhausted by the engine refer to the brake-specific emissions in grams per kilowatt-hour (g/kWh).
  • Data logging, sampling of exhaust gases and integrating measured values shall be initiated simultaneously at the start of the engine.
  • A propane check serves as a CVS verification to determine if there is a discrepancy in measured values of diluted exhaust flow.
  • The moulding of measured values on the tyre sidewalls will facilitate monitoring and enforcement of proper implementation.
  • The measured values are then compared to the interpolated values according to paragraph 5.6.3.
  • The nominal concentration of the calibration gas with the highest concentrations to be at least 80 % of the measured values.
  • The measured values shall be corrected for the effects of temperature as follows:
  • The measured values are transformed into an estimation of the lean meat percentage by a central unit.
  • Using the measured values of PL and this load profile:
  • On the vehicle representative of its type, the measured values, expressed in dB microvolts/m shall be below the type-approval limits.
  • During each mode the concentration of each gaseous pollutant, exhaust flow and power output shall be determined, and the measured values weighted.
  • During each mode, the concentration of each gaseous pollutant, exhaust flow and power output shall be determined, and the measured values weighted.
  • Where a parametric value is exceeded in a particular sample, Member States shall define the extent of resampling necessary to ensure that the measured values are representative of an average activity concentration for a full year.
  • The 4 Image-Meater variables are all measured at the split line; the measured values are transformed into estimation of a lean meat percentage by a central unit.
  • The arithmetic mean of the measured values of these three additional household refrigerating appliances shall meet the requirements laid down in Annex II within the range defined in Table 1.
  • It is necessary to indicate explicitly that the measured values are relative values equivalent to the molecular weights of the standard used.
  • For vehicles equipped with periodically regenerating systems as defined in paragraph 2.20. of this Regulation, the measured values must be multiplied by the factors Ki obtained from Annex 13.
  • plausibility of calculated substitute values and measured values,

Alternatives:

  • recorded values
  • quantified values
  • calculated values
  • observed values
  • determined values

values measured

This phrase is correct and commonly used in English.

This phrase is used when you want to emphasize the action of measuring the values. 'Values measured' can be used in various contexts to highlight the process of measurement.

Examples:

  • These are the values measured during the experiment.
  • The technician recorded the values measured by the equipment.
  • The values measured shall be given on a diagram.
  • The scale of measurement of the analysers shall be selected appropriately in relation to the values measured.
  • However, the values measured in the first few months of 2007 suggest that no improvement is to be expected before 1 January 2008.
  • If the natural logarithms of the values measured in the series are x1, x2, ..., xi and L is the natural logarithm of the limit value for the pollutant, then, define
  • The values measured for the distances shall be such that the individual specifications applicable to each lamp are fulfilled.
  • sIactual Using the values measured during the stopping manoeuvres
  • The values measured shall, if possible, be recorded at intervals of 50 m.
  • sIactual with the values measured during the stopping manoeuvre (formula 4.1)
  • The engine torque in Nm resulting from the above data stream information shall permit a direct comparison with the values measured when determining the engine power according to Regulation No 85.
  • 5.2.1.2.The values measured as specified in item 5.2.1.1 must be recorded in the test report and in a certificate corresponding to the model shown in Annex III.
  • A 10 % discrepancy, including the tolerances of photometric measurement procedure is permissible between the photometric characteristics and the values measured prior to the test.
  • A 10 % discrepancy between the photometric characteristics and the values measured prior to the test is permissible including the tolerances of the photometric procedure.
  • At the manufacturer's request the dilution air shall be sampled according to good engineering practice to determine the background particulate levels, which can then be subtracted from the values measured in the diluted exhaust.
  • The two values measured in accordance with the provisions of paragraph 6.2.1.1 shall be entered in the test report and on a form conforming to the model in Annex 1 to this Regulation.
  • None of the values measured in accordance with paragraph 2.5.2.3 of this annex exceed the limit values;
  • none of the values measured in accordance with paragraph 2.5.2.3. above exceeds the limit values;
  • At the engine manufacturers request the dilution air must be sampled according to good engineering practice to determine the background particulate levels, which can then be subtracted from the values measured in the diluted exhaust.
  • A 10 per cent discrepancy between the photometric characteristics and the values measured prior to the test is permissible including the tolerances of the photometric procedure.
  • A 10 per cent discrepancy between the photometric characteristics and the values measured prior to the test is permissible including the tolerances of the photometric procedure.
  • If necessary (e.g. in the case of uncertainty about the values measured or of unsatisfactory manoeuvres), the evasive action manoeuvres shall be repeated.

Alternatives:

  • measured quantities
  • measured data
  • measured parameters
  • measured variables
  • measured results

Related Comparisons

What Our Customers Are Saying

Our customers love us! We have an average rating of 4.79 stars based on 283,125 votes.
Also check out our 2,100+ reviews on TrustPilot (4.9TextRanch on TrustPilot).

Why choose TextRanch?

Lowest prices
Up to 50% lower than other online editing sites.

Fastest Times
Our team of editors is working for you 24/7.

Qualified Editors
Native English experts for UK or US English.

Top Customer Service
We are here to help. Satisfaction guaranteed!

×

💝 TextRanch Holidays Offer! 💝️

25% special discount
Stock up on credits for the entire year!

Grab this offer now!