TextRanch

The best way to perfect your writing.

Discover why 1,062,726 users count on TextRanch to get their English corrected!

1. Input your text below.
2. Get it corrected in a few minutes by our editors.
3. Improve your English!

One of our experts will correct your English.

Our experts

hatched area vs shaded area

Both "hatched area" and "shaded area" are correct and commonly used in English. They refer to a specific area on a diagram or map that is marked with lines or color to distinguish it from the rest. The choice between the two depends on personal preference or regional conventions.

Last updated: March 23, 2024 • 1029 views

hatched area

This phrase is correct and commonly used in English to refer to a specific area marked with lines on a diagram or map.

This phrase is used to describe an area on a diagram or map that is marked with lines or cross-hatching to differentiate it from other areas.

Examples:

  • The hatched area on the map indicates the proposed construction site.
  • Please shade the hatched area with a pencil to make it stand out.
  • The hatched area represents the endangered species habitat.
  • The hatched area is where the new building will be located.
  • The hatched area is off-limits to visitors.
  • Their rigidity is such that their force-deflection curves fall within the hatched area of Figure 2, Graph 2a.
  • The force-deflection of the impactor as a whole shall fall within the hatched area of Figure 2, Graph 2e.
  • The hatched area bounded by points 17 to 20 is typically used for footsteps.
  • The hatched area bounded by points 4, 5 and 6 is available for wheels, lifeguards, etc. only.
  • However, if the tests above were performed at a higher speed and/or the acceleration curve has exceeded the upper level of the hatched area and the child restraint meets the requirements, the test shall be considered satisfactory.
  • If the tests above were performed at a higher speed and/or the deceleration curve has exceeded the upper level of the hatched area and the Child Restraint System meets the requirements, the test shall be considered satisfactory.
  • The rigidity of block 2 is such that its force-deflection curve falls within the hatched area in Figure 2, Graph 2b.
  • The rigidity of block 4 is such that its force-deflection curve falls within the hatched area of Figure 2, Graph 2c.
  • Green hatched area Zone II [1]
  • However, if the tests were performed at a higher speed and/or the acceleration curve has exceeded the upper level of the hatched area and the safety belt meets the requirements, the test shall be considered satisfactory.

Alternatives:

  • cross-hatched area
  • lined area
  • patterned area
  • marked area
  • designated area

shaded area

This phrase is correct and commonly used in English to refer to a specific area marked with color on a diagram or map.

This phrase is used to describe an area on a diagram or map that is marked with color to distinguish it from other areas.

Examples:

  • The shaded area on the graph shows the temperature range.
  • Please color the shaded area in blue for clarity.
  • The shaded area indicates the flood-prone zone.
  • The shaded area represents the sales target for the quarter.
  • The shaded area is where the park will be expanded.
  • No rigid part of the vehicle may project into the shaded area shown on the figure.
  • Any non-insulated live part shall not be placed in the shaded area (25 kV).
  • 1. place used patch so that the sticky side covers the shaded area 2. remove backing paper 3. close adhesive label and seal 4. discard with solid waste
  • They should be located far enough from the front and rear wall of the vehicle to produce a measurable picture, avoiding wide-angle distortion in the shaded area, as shown in figure A5.3a.
  • The used patch should be placed within the open disposal label so that the sticky surface covers the shaded area on the sachet.
  • And what's this shaded area here?
  • No rigid part of the vehicle may project into the shaded area of the diagram.
  • However, within the animal enclosures, a shaded area should always be provided.
  • No metal parts shall be located in the shaded area as seen in Figure 6.
  • No rigid part of the vehicle may project to the shaded area of the diagram.
  • No rigid part of the vehicle may project to the shaded area of the diagram.

Alternatives:

  • colored area
  • tinted area
  • highlighted area
  • color-coded area
  • painted area

Related Comparisons

side effect vs side-effect azimuthal symmetry vs cylindrical symmetry side part vs side area overwritten vs l;jp;kl hide area vs hidden area secluded area vs in secluded area

What Our Customers Are Saying

Our customers love us! We have an average rating of 4.79 stars based on 283,125 votes.
Also check out our 2,100+ reviews on TrustPilot (4.9TextRanch on TrustPilot).

Why choose TextRanch?

Lowest prices
Up to 50% lower than other online editing sites.

Fastest Times
Our team of editors is working for you 24/7.

Qualified Editors
Native English experts for UK or US English.

Top Customer Service
We are here to help. Satisfaction guaranteed!