🎁 A holiday package to celebrate the season! Click here and shop now!

TextRanch

The best way to perfect your writing.

Discover why 1,062,726 users count on TextRanch to get their English corrected!

1. Input your text below.
2. Get it corrected in a few minutes by our editors.
3. Improve your English!

One of our experts will correct your English.

Our experts

function vs in equation

A complete search of the internet has found that "function" is the most popular phrase on the web.

Last updated: November 06, 2019 • 836 views

function

More popular!

6,170,000,000 results on the web

Some examples from the web:

  • My function is to repair breaches.
  • Requested function will require 43 minutes.
  • He has full function of his extremities.
  • 6 of these discontinued subjects underwent follow-up pulmonary function testing.
  • Waste accumulates, eventually proves fatal to function.
  • Hazing can serve an important psychological function.
  • This function validates an account creation request.
  • Simple on/off function through contact with the metal clip.
  • Bump height is a direct function of luminosity.
  • Linear: bump height is a direct function of luminosity.
  • The compliance function may be fulfilled by non-executive directors.
  • Pilotage services have an essential safety function.
  • Color densities will vary according to cosine function.
  • A Perl function, rendered with syntax highlighting.
  • Separate identification not required if function is combined with master lighting switch.
  • Its main function is public relations.
  • Statistically significant differences in pulmonary function tests were also observed.
  • Evaluation of motor function gave disparate results.
  • Command function is our first priority.
  • Transferring primary search function... to auxiliary display.

in equation

10,200,000 results on the web

Some examples from the web:

  • The moisture content of 0,8 volume per cent H2O is used in equation (A.-14).
  • Δdif is indeed used in homogeneous conditions in equation (2.5.34).
  • in equation 9 is replaced with nPmax× 1,02
  • If the adsorption test which was preceded, was performed with the parallel method the volume VT in equation 12 is considered to be equal to V0.
  • This can be substituted in equation (4) for D, another small term
  • To obtain an expression for the half-life we set and set in equation (1).
  • Gas flow is a function of inlet pressure and temperature, pressure drop between the SSV inlet and throat, as shown in equation 53 (see paragraph 8.5.1.4).
  • the equations (see paragraph 44) are corrected by increasing Vh in equation 3, as necessary.
  • In this case, the retrodiffraction by the walls is estimated by considering the path between source and first diffraction point R' (therefore considered as the receiver in equation (2.5.36)).
  • reference temperature, in K, being the same value as in equation 1.
  • In the particular case of observer locations behind every takeoff ground-roll segment and every landing ground-roll segment, a reduced form of the noise fraction expressed in equation (2.7.45) is used, which corresponds to the specific case of q = 0.
  • Isolating log x in equation (7), with x=1.024 in this case and using (10)
  • In equation 57, the correction shall be applied to both the measured and the background concentration.
  • Typical Electricity Consumption: Calculated Typical Energy Consumption (TEC) per Equation 3 or Equation 4 shall be less than or equal to the Maximum TEC Requirement (TECMAX) specified in Equation 6.
  • For Monitors meeting the enhanced performance display (EPD) requirements below, only one of the following Table 2 allowances shall be used in Equation 2:
  • In favourable conditions, Ḡw = Gpath in equation (2.5.17) and Ḡm = Gpath in equation (2.5.20);
  • The load points, L, are calculated as shown in equation 1.
  • The information stated here in words can also be written down in equation form:
  • It is allowed to add the thermal ageing due to the conduction of the lubricant consumption sequence to the AE calculated in equation 4.
  • The calculated value shall be used in the quench verification calculations in equation (8-4);

Related Comparisons

What Our Customers Are Saying

Our customers love us! We have an average rating of 4.79 stars based on 283,125 votes.
Also check out our 2,100+ reviews on TrustPilot (4.9TextRanch on TrustPilot).

Why choose TextRanch?

Lowest prices
Up to 50% lower than other online editing sites.

Fastest Times
Our team of editors is working for you 24/7.

Qualified Editors
Native English experts for UK or US English.

Top Customer Service
We are here to help. Satisfaction guaranteed!

×

💝 TextRanch Holidays Offer! 💝️

25% special discount
Stock up on credits for the entire year!

Grab this offer now!