🎁 A holiday package to celebrate the season! Click here and shop now!

TextRanch

The best way to perfect your writing.

Discover why 1,062,726 users count on TextRanch to get their English corrected!

1. Input your text below.
2. Get it corrected in a few minutes by our editors.
3. Improve your English!

One of our experts will correct your English.

Our experts

examine a minimum value vs examine the minimum value

Both phrases are correct, but they are used in different contexts. 'Examine a minimum value' is used when referring to any minimum value in a set of values without specifying a particular one. On the other hand, 'Examine the minimum value' is used when referring to a specific minimum value that has been previously mentioned or is known in the context.

Last updated: March 25, 2024 • 605 views

examine a minimum value

This phrase is correct and commonly used when referring to any minimum value in a set of values without specifying a particular one.

This phrase is used when you want to analyze or inspect the smallest value in a group without specifying which one it is.
  • Electrodes must be applied ear to tail with a current of a minimum value of 0,57 amperes for at least 60 seconds.
  • Potassium (K), with a minimum value of at least 250 mg/100 g product; method of analysis specified as EPA 3015A and EPA 6010B.
  • A Party may choose to express either a minimum value or a minimum quantity, or a combination of both for its commitment.
  • For two-wheel mopeds, until a minimum value for has been established, the measured value must be recorded in the test report.
  • K shall have a minimum value of 4, and
  • As regards sugar content, national legislation on the certification conditions of this product imposed a minimum value of 11º Brix, which corresponds to production practices.
  • When fixing a minimum value, a minimum difference of 2R above zero was taken into account. When fixing a maximum and minimum value, the minimum difference used was 4R (R = reproducibility).
  • If AC high voltage buses and DC high voltage buses are galvanically connected isolation resistance between the high voltage bus and the electrical chassis shall have a minimum value of 500 Ω/volt of the working voltage.
  • The height of the microphone above the ground should be equal to that of the outlet pipe of the exhaust gases, but in any event shall be limited to a minimum value of 0,2 m.
  • Since the photometric values required for front fog lamps do not cover the full geometric field of vision, a minimum value of one cd in the space remaining is required for type-approval purposes.
  • Each IUPRm ratio shall have a minimum value of zero and a maximum value of 7,99527 with a resolution of 0,000122 [1].
  • Since the photometric values required for dipped-beam headlamps do not cover the full geometric field of vision, a minimum value of 1 cd in the space remaining is required for type-approval purposes.
  • Each IUPRm ratio shall have a minimum value of zero and a maximum value of 7,99527 with a resolution of 0,000122 [1].
  • Insert the minimum value for file access date that you want to search, or leave it unchecked if you do not want a minimum limit.
  • I voted for this report, which examines a Commission proposal to extend by 5 years to 31 December 2015 the requirement for EU countries to have a minimum standard VAT rate of 15%.
  • K1= a factor related to the service temperature and the thermal properties of the resin, determined by the following equation, with a minimum value of 1:
  • Find the minimum value of the graph in a specified range. The selected graph will be highlighted in the dialog that appears. Enter the lower and upper boundaries of the region in which you want to search for a minimum.
  • If AC high voltage buses and DC high voltage buses are galvanically connected isolation resistance between the high voltage bus and the electrical chassis shall have a minimum value of 500 Ω/volt of the working voltage.
  • Where both a minimum value and a maximum value are specified for the mass or footprint values referred to in point 1(i) for a passenger car, Member States shall use only the maximum figure for the purposes of this Regulation.
  • have been applied and in fixing a minimum value, a minimum difference of 2R above zero has been taken into account; in fixing a maximum and minimum value, the minimum difference is 4R (R = reproducibility).

Alternatives:

  • analyze a minimum value
  • inspect a minimum value

examine the minimum value

This phrase is correct and commonly used when referring to a specific minimum value that has been previously mentioned or is known in the context.

This phrase is used when you want to analyze or inspect a particular smallest value that has been identified or discussed earlier.
  • Increasing the minimum value for which declarations are considered for physical checks could result in a significant reduction in the number of items to be checked.
  • The minimum value accepted is 70 %.
  • The minimum value of 34 J/cm2 shall be required in every case.
  • Rm/20 indicates the minimum value of the ultimate strength 20 ºC.
  • The export obligation is subject to the minimum value addition requirement of 20 %.
  • Enter the minimum value for the display here.
  • Find the minimum value of the graph in a specified range.
  • On high-speed lines the minimum value is 0,95 under the conditions described in the abovementioned document.
  • The minimum value at the evacuation thresholds has to be >= 30 lux.
  • However each of the two front fog lamps shall meet at least 50 per cent of the minimum value required for line 6.
  • The sampled lamp shall be subjected to photometric measurements for the minimum values at the points listed in Annex 4, and the required chromaticity coordinates.
  • The average IUPRM is equal or above the minimum value applicable to the monitor
  • Comments regarding the extent of coverage of the conspicuity marking if it is less than the minimum value of 80 % required by paragraphs 6.21.4.1.2. and 6.21.4.2.2.
  • Enter the minimum value for the display here. If both values are 0, automatic range detection is enabled.
  • The sampled lamp shall be subjected to photometric measurements for the minimum values at the points listed in Annex 4 and the required chromaticity coordinates.
  • The minimum value is 250 mg/100 g, determined by means of 'EPA 3015A/EPA 6010B' analysis.
  • It shall take the minimum value of the range referred to in Step 3 of Annex I for all other institutions.
  • It is recommended that the minimum size for an indoor enclosure should meet the minimum values specified to ensure that the animals are not overcrowded in inclement weather.
  • Minimum force: the minimum value of the contact force.
  • The minimum value for the evacuation signs has to be >= 50 lux.

Alternatives:

  • analyze the minimum value
  • inspect the minimum value

Related Comparisons

What Our Customers Are Saying

Our customers love us! We have an average rating of 4.79 stars based on 283,125 votes.
Also check out our 2,100+ reviews on TrustPilot (4.9TextRanch on TrustPilot).

Why choose TextRanch?

Lowest prices
Up to 50% lower than other online editing sites.

Fastest Times
Our team of editors is working for you 24/7.

Qualified Editors
Native English experts for UK or US English.

Top Customer Service
We are here to help. Satisfaction guaranteed!

×

💝 TextRanch Holidays Offer! 💝️

25% special discount
Stock up on credits for the entire year!

Grab this offer now!