calibration of meter vs calibration meter

Both phrases are correct, but they have slightly different meanings. 'Calibration of meter' refers to the action of calibrating a meter, while 'calibration meter' refers to a specific type of meter used for calibration. The choice between the two depends on the context in which they are used.

Last updated: March 30, 2024

calibration of meter

This phrase is correct and commonly used in English.

This phrase is used when referring to the process of calibrating a meter. It indicates that the meter is being calibrated.

Examples:

The calibration of the meter was done annually to ensure accuracy.
Proper calibration of the meter is essential for accurate measurements.

Show examples from the web [+]

Measure the pH value of the clear solution at a temperature of 20 (± 1) ºC according to the same procedure as for the calibration of the meter.
Deviations in calibration of sound level meter: ...dB(A)
Accurate calibration of the flow meters relative to one another is required, since the relative magnitude of the two flow rates can lead to significant errors at higher dilution ratios (of 15 and above).
Ideally, at greater intervals, a spectroradiometer should be used to measure the spectral irradiance of the filtered light source and to check the calibration of the broadband UV-meter.
An in-situ calibration of the CVS flow-meter shall be performed as described in paragraph 8.1.8.4.;
The calibration of the heat flux meter shall be checked whenever a recalibration of the radiator is carried out, by comparison with an instrument held as a reference standard and not used for any other purpose.
Leaks between the calibration flow-meter and the CFV shall be less than 0,3 per cent of the total flow at the highest restriction;
This calibration shall be performed after any part of the flow configuration upstream or downstream of the flow-meter has been changed that may affect the flow-meter calibration.
If it can be demonstrated by records of the calibration procedure under paragraph 9.4.6.2. that the flow meter calibration is stable over a longer period of time, the pre-test check may be omitted.
This reference flow-meter's response to flow shall be used as the reference value for CVS flow-meter calibration;
The calibration of the particulate measurement is limited to the flow meters used to determine sample flow and dilution ratio.
For calibration of the radiator, a heat flux meter (radiometer) of the Gardon (foil) type with a design range not exceeding 10 W/cm² shall be used.
Calibration of tracer gas analyser for exhaust flow measurement
The calibration of his hand touch receptors must be off.
This Directive concerns EEC calibration of the tanks of inland waterway vessels and of coasters.
Appendix 3 Calibration of portable measurement equipment
Calibration of tools and equipment, calibration standards.
Proceeding with final calibration of positron acceleration chamber.
For calibrations of the analytical equipment the provisions of Annex 4a apply.
Directive 71/349/EEC on Calibration of Ship Tanks.

Alternatives:

meter calibration
calibrating the meter
meter calibration process
meter calibration procedure
meter calibration service

calibration meter

This phrase is correct and commonly used in English.

This phrase refers to a specific type of meter that is used for calibration purposes. It indicates that the meter is designed for calibration.

Examples:

The lab technician used a calibration meter to adjust the equipment.
Make sure to use a calibration meter for precise measurements.

Show examples from the web [+]

Leaks between the calibration flow-meter and the CFV shall be less than 0,3 per cent of the total flow at the highest restriction;
Measure the pH value of the clear solution at a temperature of 20 (± 1) ºC according to the same procedure as for the calibration of the meter.
Deviations in calibration of sound level meter: ...dB(A)
This calibration shall be performed after any part of the flow configuration upstream or downstream of the flow-meter has been changed that may affect the flow-meter calibration.
Accurate calibration of the flow meters relative to one another is required, since the relative magnitude of the two flow rates can lead to significant errors at higher dilution ratios (of 15 and above).
If it can be demonstrated by records of the calibration procedure under paragraph 9.4.6.2. that the flow meter calibration is stable over a longer period of time, the pre-test check may be omitted.
This reference flow-meter's response to flow shall be used as the reference value for CVS flow-meter calibration;
This calibration shall be performed while the flow-meter is installed in its permanent position.
The test must be considered invalid if the sound-level meter errors registered during this calibration exceed 1 dB.
The pH-meter shall be calibrated properly in the range of pH 4 to pH 7 following normal laboratory pH-calibration procedures.
If a pressure-meter of the prescribed quality is used e.g. capsulated with a steel membrane, no calibration is necessary in the laboratory.
The calibration of the particulate measurement is limited to the flow meters used to determine sample flow and dilution ratio.
Ideally, at greater intervals, a spectroradiometer should be used to measure the spectral irradiance of the filtered light source and to check the calibration of the broadband UV-meter.
An in-situ calibration of the CVS flow-meter shall be performed as described in paragraph 8.1.8.4.;
This calibration procedure is based on the measurement of the absolute values of the pump and flow-meter parameters that relate the flow rate at each point.
For calibration of the radiator, a heat flux meter (radiometer) of the Gardon (foil) type with a design range not exceeding 10 W/cm² shall be used.
evidence of the maintenance and accuracy/uncertainty of measurement equipment/flow meters (e.g. calibration certificates);
The accuracy of the calibration can be checked in the laboratory with a one-point measurement at 1× 105 Pa against a pressure-meter with a mechanical display.
The following paragraphs give details of methods of calibrating PDP and CFV units, using a laminar flow-meter, which gives the required accuracy, together with a statistical check on the calibration validity.
Alternatively, a special calibration flow pathmay be provided, in which the tunnel is bypassed, but the total and dilution air flow through the corresponding meters are maintained as in the actual test.

Alternatives:

calibrator meter
meter for calibration
calibration equipment
calibration device
calibration tool

What Our Customers Are Saying

Our customers love us! We have an average rating of 4.79 stars based on 283,125 votes.
Also check out our 2,100+ reviews on TrustPilot (4.9).

"Thank you!"
Sachi Nakama July 2024
"I have literally been through chat, PI, claude, bard and bing and I got conflicting answers! Thank you! Human intelligence reigns!"
Retha July 2024
"Faster than AI"
CYNTHIA December 2023
"This was very helpful and I personally think this site is the best."
Kaden October 2023
"It was extremely thorough and very helpful!"
imperialelisa October 2023
"7 years without any disappointment. Always 100% satisfied. You guys are the best in the world at what you do. Thank you so much :)"
Zubair Alam October 2023
"In a world of text messages and online communication, this is great to have as a live tool. Thank you."
Selena October 2023
"Without textranch I would be stuck!"
宏祐 October 2023
"Accuracy and fast response. Personal comments from editor. Thank you."
Clh September 2023
"I wasn't aware of this service, it's fascinating and more reliable than standard IA tools available on the internet"
Arturo September 2023
"The fact that you can get reliable fast feedback on your texts."
Vinicius Antonio August 2023
"you guys are better than grammarly i'm being honest here"
ordinary July 2023
"OMG! This is really good than any other text correction tools I've used so far. Highly recommend this."
Vehan July 2023
"Very fast and accurate. thank you."
mojtaba July 2023
"I love this app because it's help to writing skills all of students ♥️"
Tarisini July 2023
"This was exactly the mistake I was looking for, the wording dind´t sound right at first. Better than grammarly!"
Ente July 2023
"The immediate help that I received was reassuring and very satisfactory. Thanks."
priiiyanshuu July 2023
"this helps A LOT for my studies."
kathnunez02 June 2023
"Woow!! I would never have expected such precision! Thank you soooo much!!"
Berta June 2023
"Real Time Editor and not AI. Many Thanks."
Priya June 2023
"The very first thing excites me about Textranch is how much your editors care."
sepideh June 2023
"The fact that texts are checked by human editors rather than by AI, etc. I appreciate this!"
Анна June 2023
"Feel welcome, immediate response, high quality feedback"
martin.roy June 2023
"This is the best app that I have ever seen"
Burulai May 2023

calibration of meter vs calibration meter